Product Description; Combination Possibilities; Indications For Use - Ottobock 9X50 Gebrauchsanweisung

2 Product description

2.1 Function
9X50 linear control element function
The 9X50 linear control element is installed in the definitive socket. The
switching points are reached by pulling on the bow. When the 9X50 linear
control element is not under load, the control signal is 0 volts. When the bow
is pulled to maximum, the control signal corresponds to the maximum elec­
trode signal of an electrode.
9X51 4-stage control element function
Pulling on the bow of the 9X51 4-stage control element generates a control
signal. Output signals of various strengths are simulated depending on the
ratchet position, making it possible to switch between the various compon­
ents with corresponding configuration of the prosthesis.

2.2 Combination possibilities

The product can be combined with components of the Ottobock MyoBock
system and Axon-Bus prosthetic system. Components from other manufac­
turers cannot be used with this product.
System components
• DynamicArm: 12K100N/12K110
• ErgoArm Hybrid plus: 12K44
• ErgoArm Electronic plus: 12K50
• System Electric Hand DMC plus: 8E38=6, 8E39=6, 8E41=6
• System Electric Hand Digital Twin: 8E38=7, 8E39=7, 8E41=7
• Sensor Hand Speed: 8E38=8, 8E39=8, 8E41=8
• MyoHand VariPlus Speed: 8E38=9, 8E39=9, 8E41=9
• Transcarpal Hand DMC plus: 8E44=6
• Transcarpal Hand Digital Twin: 8E44=7
• System Electric Greifer Digital Twin: 8E33=7, 8E34=7
• System Electric Greifer DMC VariPlus: 8E33=9, 8E34=9
• Electric Wrist Rotator: 10S17
• MyoRotronic: 13E205
3 Application

3.1 Indications for use

The product is to be used solely for upper limb prosthetic fittings.
The product is intended exclusively for use on one patient. Use of the
product by another person is not approved by the manufacturer.
Ottobock | 11