Controls And Functions - Eizo MammoDuo RX560 Zusätzliche Informationen

Controls and Functions

For information about the part names and functions of the monitor unit, refer to "Controls and Functions"
in the Instructions for Use.
Rear view
1. Mount unit
2. Handle
3. Stand
4. Cable holder
5. Rotation screw
6. Swivel lock screw
7. Tilt lock
8. Mount lock
2
Top view
1
2
3
4
Connects the monitor unit to the stand.
This handle is used for transportation.
The stand enables you to:
• Adjust the position and horizontal angle of each monitor.
• Adjust the vertical / horizontal angle and height of the entire monitor
Holds the monitor cables.
By rotating this screw, each monitor screen can be turned clockwise or
counterclockwise to adjust the size of the space between the monitors.
Tightening this screw locks the horizontal angle.
Note
• The screw is not locked before shipment.
Locks the vertical angle of the monitor to 0˚.
: Locked, : Released
Note
• The angle is locked to 0˚ before shipment. To change the monitor tilt angle, release
the lock.
• When transporting the product, set the vertical angle of the monitor to 0˚ and apply
the tilt lock. This helps make transportation of the product easier.
Locks the mount unit to the stand unit.
To remove the mount unit from the stand unit, release the mount lock.
: Locked, : Released
5
6
7
8