Inhaltsverzeichnis
Werbung
en
Installation
Installation location
Install the appliance in a dry, well
ventilated room. The appliance should
not be installed in direct sunlight or near
a heat source such as a cooker, radiator,
etc. If installation next to a heat source
is unavoidable, use a suitable insulating
plate.
Observe the following minimum distances
to heat sources:
S 3 cm to electric or gas cookers.
S 30 cm to an oil or solid fuel cooker.
If installing the appliance next to another
refrigerator or freezer, there must be
a minimum gap of 2 cm between
the appliances in order to prevent
condensation.
Aligning the appliance
Fig. 2/A
The appliance must be level. If the floor
is uneven, use the front height adjustable
feet.
22
Changing over the door
hinges
d Warning!
While changing over the door hinges,
ensure that the appliance is not
connected to the power supply. Pull out
the mains plug beforehand. Tilt back
the appliance (if required, place
packaging material, etc. underneath).
Appliance door
Fig. 3
The door hinges can be changed over
if required by the installation location.
Installation in numerical sequence.
Freezer compartment door
Fig. 4
Installation in numerical sequence.
Werbung
Inhaltsverzeichnis
