Commissioning; Operation; Placing The Bonnet On The Buffing Plate; Applying Wax / Polish With The Terry Bonnet - Parkside XQ90 Bedienungs- Und Sicherheitshinweise

Commissioning / Operation / Cleaning and Maintenance

Commissioning

Q
The mains voltage at the mains socket must match
that shown on the rating plate on the device. Devices
marked with 230 V ~ can also be operated at
220 V ~ .

Operation

Q
Placing the bonnet on the
Q
buffing plate
1. Turn the waxer/polisher over so that the polish-
ing disc is pointing upwards.
2
2. Place the bonnet
5 6
plate . Ensure that the bonnet
2
placed centrally and taughtly onto the buffing
plate.
Applying wax / polish
Q
with the terry bonnet
1. Always use high quality products for waxing.
j
Follow the working methods given on the
packaging.
2. Apply the wax / polish directly on the working
surface of the terry bonnet
j
Spread the wax / polish so that it forms a thin,
even, complete coating over the terry bonnet
Note: Too much wax does not necessarily
achieve a better finish and you will have to
spent more time later removing the coating.
3. Spread the wax evenly right up to the edge of
the terry bonnet
5
Switching on the device
Q
and waxing / polishing the
paintwork
Note: The paintwork to be polished must be care-
fully cleaned and completely dry. If necessary, use
a paintwork cleaner. Use products that are appro-
priate for the demands on and condition of your
paintwork. Heavily oxidised paintwork will require
10 GB
over the buffing
is
5 6
.
5
.
the use of a special cleaner. For this use a combined
product (cleaner + wax).
1. Place the waxer/polisher on the surface to be
polished.
Note: To avoid the splattering of wax or polish,
do not switch the appliance on yet. Dab the
appliance a few times at various points on the
area to be buffed. In this way you can ensure
that excess wax / polish is once more distributed
evenly over the terrycloth bonnet and the area
to be buffed.
2. Take both appliance grips
hands and switch the appliance on by pressing
the On / OFF switch
3. Guide the waxer/polisher evenly over the
paintwork (see Fig. C).
Note: Do not press on the waxer/polisher!
The self-weight of the waxer / polisher alone
applies sufficient pressure for the waxing / pol-
ishing process.
4. Switch the appliance off before you remove it
from the area being buffed. To do this, release
the On / OFF switch
j
Any difficult to reach corners or recesses may
have to be completed later by hand. Take the
terry bonnet
use the bonnet for the corners and recesses.
Polishing or removing wax with
Q
.
5
the synthetic polishing bonnet
Note: The wax / polish must be allowed to dry on
sufficiently to produce the best polishing performance.
Otherwise any polish that is still fluid will be smeared
by the polishing bonnet.
j
Use the synthetic polishing bonnet
polishing or removing the wax.
j
When working, always follow the instructions
for use of the wax / polish.
Cleaning and Maintenance
Q
WARNING!
Switch the device off and pull the plug out of the
firmly in your
1
(see also Fig. B).
3
.
3
off the waxer/polisher and
5
6
DANGER OF INJURY!
for final