Herunterladen Diese Seite drucken

Line Voltage Change Over - Agilent Technologies MiniVac 929-0190 Bedienungshandbuch

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

WARNING!
The MiniVac controller is equipped with a 3-wire power cord and plug
(internationally approved) for user's safety. Use this power cord and plug in
conjunction with a properly grounded power socket to avoid electrical
shock.
High voltage developed in the controller can cause severe injury or death.
Before servicing the unit, disconnect the input power cable.
The MiniVac controller can be used as a bench unit or as a rack module, but it
NOTE
must be positioned so that free air can flow through the holes.

Line Voltage Change Over

If a change in line voltage operation is desired, proceed as follows:
1.
2.
3.
4.
5.
6.
MiniVac Controller User Manual / 87-900-049-01 (H)
Unplug the power cord from the controller rear panel socket.
On the power entry module (rear panel), check back door for
voltage selector set.
Using a small screwdriver, pull out the voltage selector and fuses.
Select the operating voltage, then firmly insert the voltage
selector and fuses in place.
Check voltage selector window for correct set and connect the
power cord.
For Line Voltage between 200 and 230 Vac set the voltage selector
to 220 Vac; for Line Voltage higher than 230 Vac set the voltage
selector to 240 Vac.
Technical Information
Installation
5
57/70

Werbung

loading