Roland Edirol Studio Canvas SD-20 Bedienungsanleitung Seite 24

Getting connected and installing drivers (Windows)
7
Exit all currently running software (applications).
Also close any open windows. If you are using virus checking or similar
software, be sure to exit it as well.
8
Prepare the CD-ROM.
Insert the CD-ROM into the CD-ROM drive of your computer.
9
Open the "Run..." dialog box.
Click the Windows Start button. From the menu that appears, select "Run..."
fig.2-14_40
10
In the dialog box that appears,
input the following into the
"Open" field, and click [OK].
D:\DRIVER\USB_XP2K\SETUPINF.EXE
* The drive name "D:" may be different for your system. Specify the drive name of your
CD-ROM drive.
fig.2-15_40
11
The SETUPINF dialog box will
appear.
You are now ready to install the
driver.
* Do not click [OK] at this time.
12
Connect the SD-20.
1. Set the computer switch of the SD-20 to USB.
2. With the SD-20's power switch turned off, connect it to the AC
adaptor.
3. Plug the AC adaptor into an AC power outlet.
4. Use the USB cable to connect the SD-20 to your computer.
13
Set the SD-20's power switch to the ON position.
24
In this manual, the location
of folders and files is given
in terms of the file path,
using \ as the delimiter. For
example,
USB_XP2K\SETUPINF.E
XE indicates the
SETUPINF.EXE file found
in the USB_XP2K folder.
Even if you will normally
be using the SD-20 with
BUS power, please use the
AC adaptor while you are
installing the driver and
making settings.
This unit is equipped with
protection circuit. A brief
interval (a few seconds)
after power up is required
before the unit will operate
normally.