Aventics PROFINET VS serie Betriebsanleitung Seite 72

72 AVENTICS | PROFINET | R412023897–BDL–001–AA
Commissioning and Operation
The procedure to assign a name to the bus coupler depends
on the PLC configuration program. Please see the operating
instructions for the program for more information.
The following example is based on the SIMATIC software from
Siemens. The PLC configuration can also be done using a
different PLC configuration program.
Danger of injury if changes are made to the settings during
operation.
Uncontrolled movement of the actuators is possible!
O
Never change the settings during operation.
To edit the correct device:
1. First look for the participant that you would like to edit. In
this example, it is the CL03 series bus coupler.
The bus coupler is shown with the IP address 0.0.0.0 (or an
already-configured address).
2. Select the bus coupler.
CAUTION