Start Up - Parkside PISG 120 A1 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

Start up

z Start up
Note: The welding tool is suitable for weld-
ing with electrodes.
Use electrode retaining clips without pro-
„
truding retaining screws meeting today's
safety standards.
Be sure the ON / OFF switch
„
position "O" ("OFF") or the main supply
cable is not plugged into the mains
10
socket.
Connect the welding cables according
„
to polarity and electrode manufacturer
instructions.
To do so, connect the port of the earth
„
terminal (black) with the appropriate
4
outlet on the inverter welding machine
(black, marked with "-").
Connect the port of the electrode holder
„
(red) with the appropriate outlet on
5
the inverter welding device (red, marked
with "+"),
Put on suitable protective clothing
„
according to provisions and prepare the
work area.
Connect the earth terminal
„
workpiece.
Secure the electrode in the electrode
„
holder .
5
Switch on the device by setting the ON /
„
9
OFF switch to the "I" ("ON") position.
Set the welding current with the control
„
knob according to the electrode used.
3
Note: Please see the table below for the
welding current according to electrode
diameter.
Ø Electrode
1.6
2.0
2.5
3.2
14 GB
9
is set to
4 to the
welding current
40 – 55 A
55 – 65 A
65 – 80 A
80 – 120 A
Note: For the welding currents of 80 A to
120 A, please use welding electrodes with
a diameter of 3.2 mm (not included in the
scope of delivery).
Attention: Do not bring the earth
4
terminal and the electrode holder
electrodes into direct contact with one
another.
Attention: When welding with elec-
trodes (MMA - manual metal arc
welding) the electrode holder
4
earth terminal
to positive (+) or negative (-) according
to the welding rod specifications.
Hold the welding shield
„
your face and begin welding.
To stop working, set the ON / OFF
„
switch 9 to the "O" ("OFF") position.
ATTENTION!
When the thermal overload protection is
triggered, the yellow control lamp
up. In this case, no further welding is
possible. The device is still in operation for
the fan to cool the device. As soon as the
device is ready for use again, the yellow
control lamp switches off automatically.
2
The welding function is now given again.
ATTENTION!
Be careful not to rub the welding rod against
the workpiece. This could damage the
workpiece and make it difficult to strike an
arc. Maintain the proper distance to the
workpiece after striking the arc. The distance
should correlate to the diameter of the
welding rod used. Maintain this distance as
accurately and consistently as possible whilst
welding. The angle between the welding
rod and the working direction should be
between 20 and 30 °.
5
/
5 and the
lug must be connected
7
in front of
lights
2