Changing The Viewing Angle; Adjusting The Volume - Clatronic dvd 797 Bedienungsanleitung

Themen Playing media

Changing the viewing angle

Adjusting the volume

Creating a playlist (DVD)
Deleting a playlist (DVD)
44
05-DVD 797_GB.indd 44 05-DVD 797_GB.indd 44
NOTE:
With the cursor buttons (Fig. 3/20) you can move through the zoomed image.
Some DVDs offer the possibility to select the viewing angle.
Press the ANGLE button (Fig. 3/29) to change the viewing angle.
NOTE:
If changing the Viewing Angle is not possible, the message „ " will be displayed.
Repeat pressing the the button to choose a different viewing angle, or to return to
the original viewing angle.
Press the VOL + button (Fig. 3/15) to increase the volume.
Press the VOL - button (Fig. 3/16) to reduce the volume.
NOTE:
Please remember, that this will only change the output volume of the DVD-
Player. In order to adjust the volume to your requirements you may also have to
change the volume of the playback device.
It is possible that you may not wish to play the titles in the same order that they
are to be found on the DVD. The function „Create Playlist" you can create your
own playing order.
To do this, proceed as follows:
1. Press the PROG button (Fig. 3/27). A table is displayed. Here you can enter
the desired order of the chapters/titles.
NOTE:
However, your playlist will be lost when switching off the DVD-Players or
when inserting a new DVD.
2. Use the Cursor Buttons (Fig. 3/20) to navigate in the table.
3. Enter the desired title and chapter at the relevant position in the table. Use the
Numerical Buttons (Fig. 3/3) for this purpose.
4. Store your entry by selecting the " Play" command with the Cursor But-
tons (Fig. 3/20) at the edge of the table.
5. Press the ENTER button (Fig. 3/13) on the remote control to confi rm this
command.
1. Press the PROG button. You will now see a table.
2. Use the Cursor Buttons (Fig. 3/20) to go to the "Clear program" command at
the edge of the table.
3. Press the ENTER button (Fig. 3/13) on the remote control to confi rm this
command.
4. Press the PROG button to terminate this procedure.
18.08.2008 15:58:23 Uhr 18.08.2008 15:58:23 Uhr