MSA GAG serie Handbuch Seite 22

INNER SHELL AND PADDING
INNER SHELL AND PADDING
5
• Remove the four fixing screws and carefully
remove the inner shell and padding in order not to
damage the shield and goggles.
Note:
A) Insert the inner padding
B) Reassemble the inner shell
helmet
SAFETY GOGGLES
6
• Remove the safety goggles (b) from the inner
shell (d) (two TORX screws).
Caution:
During re-assembly, check the order of
components and the direction of the discs
(a)(c).
FACE SHIELD
7
• Remove the face shield (f) maintained by
springs (e) in the shell (g) (2 TORX screws).
Caution:
During re-assembly, check the position of
the spring indexing notches (h) in their
housing.
20
- Assemble the right side (2 screws)
- Fit the inner shell in the bottom of the
- Assemble the left side (2 screws)
SAFETY GOGGLES
FACE SHIELD
The Safety Company
(a) (b) (c) (d)
(h)
(e) (f) (g)