Controlling Ptz Movements - Videotec ULISSE IR360 Bedienungsanleitung

When setting up manually, it is essential (as in
automatic setup, apart from the IP address) to set the
items marked by an asterisk, i.e.
Camera ID: Consecutively, 1, 2, 3 etc.
Camera IP: E.g. 192.168.0.102
Camera Model: Select 1-CH Video Server
Fig. 133
Set the name that will appear in the Camera Tree:
Camera Name: E.g. ULISSE 2
On completion, click on Apply and wait until the
settings have been saved.
Repeat the procedure for all the other devices
present in the system.
On completion of this stage, you should
h
close the NVR program and re-start it so
that the changes take effect. When the
program is restarted, the Camera Tree
should contain a list of the units in the
system for which settings have been made.
From the Media Source list, drag & drop the first
unit into one of the blue windows, and the live video
image should appear.
Fig. 134 Example of drag & drop.
Repeat the procedure for the other units.
54

9.7.3.1 Controlling PTZ movements

To set movement control via the control panel or via
mouse, proceed as follows:
Select the Setup / Setup Camera menu and select
the PTZ tab.
Select the first unit, or the one you want to configure,
from the Media Source list. Check the Enable PTZ
box. Then click on Apply. This will automatically set
the Videotec Macro protocol at 38400 baud.
Fig. 135
Repeat the procedure for the other units to be
controlled, directly from the PTZ setup menu (see
illustration above); just select the other units present
in the Media Source list of the Camera Tree menu,
one at a time, and check Enable PTZ, then click on
Apply.
h When the unit settings have been inserted,
quit the NVR programm and re-start it so
that all the changes will be saved.
To control a unit via the control panel, select the unit
to be controlled by clicking with the mouse on the
corresponding video window, and then operate from
the control panel.
Fig. 136