Parkside PDOS 200 C2 Originalbetriebsanleitung Seite 32

GB MT
• Ensure that the rotation speed
stated on the grinding disc
(
10) is the same or higher
than the nominal rotation speed
of the device.
• Ensure that the grinding disc
dimensions match those of the
device.
• Only use flawless grinding discs
(sound test: an undamaged grind-
ing disc hanging freely on a
string will result in a clear sound
if it is tapped with a plastic ham-
mer).
• Never re-drill a locating hole
which is too small to make it
larger.
• Never use separate bushings or
adapters in order to make grind-
ing discs whose hole is too large
fit the device.
• Do not use any saw blades.
• To clamp the grinding tools only
use the clamping flange provid-
ed. The pads between the clamp-
ing flange and the grinding tools
must be made of elastic materials
e.g., rubber, soft cardboard etc.
• Always reassemble the device
completely after replacing the
grinding disc.
Switch the device off and remove
the mains plug.
Allow the device to cool down.
Wear protective gloves when
changing the grinding discs in or-
der to avoid cutting damages.
The grinding disc nuts (
have different threads (left-hand
and right-hand threads). To avoid
32
1. Undo the fixing screws (
2. Unscrew the grinding disc nuts
3. Remove the clamping flange
4. Set up the new grinding disc
5. Screw the left hand and right
6. Adjust the spark protection
10a)
damaging the grinding disc spindle
thread (
15), never mix up the
two grinding disc nuts (
and remove the left-hand and
right-hand grinding disc cover
(
8).
(10a) by counter-holding the nut
on the opposite grinding disc
with a spanner (size 19 mm).
Unscrewing the left-hand nut
(left-hand thread): turn clock-
wise.
Unscrewing the right-hand nut
(right-hand thread): turn anti-
clockwise.
(10b) and the grinding disc
(10).
(10) with the intermediate shims
(10c) made of cardboard and
the clamping flange (10b) and
manually screw the grinding disc
nut (10a) on.
Screwing the left-hand nut (left-
hand thread) on: turn anticlock-
wise.
Screwing the right-hand nut
(right-hand thread) on: turn
clockwise.
hand grinding disc covers (8)
on.
(
1) and the workpiece sup-
port (
11): The distance to the
grinding disc (10) must not ex-
ceed 2 mm (see "Assembly").
10a).
7)