EFOY Pro 800 Bedienungsanleitung Seite 29

5. Data Port Commands
Command
SET id:value
(MIN/MAX/STD)]
Output in the terminal program
The command 'SET id:value' changes the value of a parameters. With this
command it is possible to set up the same values as with CONFIG and
DEFAULT. The list of parameters (ID-number) can be requested with the
command SFC>GET LIST .
Example:
SFC>SET 018:12000
Sets the parameter 'switch on voltage @ 12V' to 12000 mV.
SFC>SET 018:STD
Sets the parameter 'switch on voltage @ 12V' to the standard value
12300 mV.
SFC>SET 018:MIN
Sets the parameter 'switch on voltage @ 12V' to the feasible minimum
value 11000 mV.
SFC>SET 018:MAX
Sets the parameter 'switch on voltage @ 12V' to the feasible maximum
value 13000 mV.
26