Operation; Switching On And Off; Inserting/Replacing The Blade; General Working Instructions - FLORABEST FGS 3.6 A1 Originalbetriebsanleitung

3. Connect the power supply unit
(15) to a socket.
The charging indicator (6) lights up:
Red: Equipment charging.
Green: Charging finished.
The recommended charging time
is max. 3 – 5 hours.
4. After the recharging process
is completed, first unplug the
charger from the wall outlet, and
then remove the charger cable
plug (16) from the tool.

Operation

Keep to noise abatement regula-
tions and other by-laws.

Switching on and off

1. Remove the blade guard (11/14)
before switching the unit on.
2. Insert the safety key (7) into the
device.
3. To switch on, hold the switch
lock (2) depressed and operate
the on/off switch (8). Then re-
lease the switch lock.
The equipment runs at top
speed.
4. In order to switch off, let go of
the on/off switch (8).
After switching the unit
off, the blades take a short
time to stop moving. Let the
blades come to a complete
standstill. Do not touch the
blades or slow them down
before the moving parts have
come to a standstill.

Inserting/replacing the blade

Prior to each exchange of the
blades, make sure the device
is switched off and the safety
key and in order to avoid
danger and injuries!
Remove blade
1. Press the unlock buttons (10/13)
on the blade and remove the
entire blade.
Insert blade
2. Insert the grass shear blade (9) or
the shrub shear blade (12) into
the recess in the cutter head (1).
3. Press the blade into the direction
of the cutter head (1). It locks
into place audibly.

General working instructions

While trimming, take care that there
are no objects such as wire, metal
parts, stones etc. come into contact
with the blades. This can lead to
cutting head damage. If the blades
become blocked by solid objects,
switch off the unit at once.
• Check the grass and bush trimmer
blades for obvious defects such as
loose, worn or damaged parts. Check
that the screws are seated firmly in the
blade block.
• Remove the power supply unit (
before working with the equipment. Do
not use extension cables. The power
supply unit is to be used only in en-
closed spaces.
• Only use sharp blades to achieve a
good cutting performance and pre-
serve the battery.
GB IE
15)
33