Charging Process - FLORABEST FGS 3.6 A1 Originalbetriebsanleitung

GB IE
ger outdoors. Dirt and the
entry of water increase the risk
of electric shock.
g) Operate the charger only
with the appropriate ori-
ginal batteries. Charging
other batteries may result in
injuries and risk of fire.
h) Avoid mechanical damage
to the charger. This can result
in internal short circuits.
i) Do not operate the char-
ger on a combustible sur-
face (e.g. paper, textiles).
Risk of fire due to heating du-
ring charging.
k) If the power cable for this
equipment is damaged, it
must be replaced by the
manufacturer, a customer
service agent of the same
or a similarly qualified per-
son in order to prevent hazards.
l) Do not use the charger to
charge non-rechargeable
batteries.
m) Do not connect a dama-
ged cable to the power
supply. Do not touch a da-
maged cable before it has
been disconnected from
the power supply, as you
could come into contact
with active parts.

Charging process

Do not expose the battery to
extreme conditions such as
heat and impact. There is a
risk of injury from leaking
electrolyte solution! In case
of contact, rinse with water
or neutraliser and consult a
32
doctor if contact has occurred
with eyes etc.
Charge the battery only in
dry areas.
Do not switch on the device
while charging it and make
sure that the safety key (
7) has been removed.
There is a risk of injury from
electric shock.
Ensure that the equipment is
charged for no longer than
3-5 hours without interruption. The
battery and equipment could be
damaged and they consume energy
unnecessarily in case of longer
charging time. Overcharging invali-
dates the guarantee.
• The device may only be powered with
SELV (Safety Extra Low Voltage) as
marked on the device.
• Before initial use, charge the battery
installed in the equipment. Do not
charge the battery for several short pe-
riods in succession.
• Use the charger supplied to charge
the Li-ion battery installed in the equip-
ment.
• Recharge the battery if the equipment
runs too slowly.
• In all cases, observe the applicable
safety information as well as the regu-
lations and directions for environmen-
tal protection.
• Defects resulting from improper han-
dling are not subject to the guarantee.
1. Remove the safety key (7).
2. Connect the charger cable plug
(16) with the charger socket on
the tool (5).