ESAB POWERCUT-1500 Bedienungsanleitungen Seite 112

SECTION 3
G. When ending a cut, the torch switch should be released (press and
release if using trigger LOCK mode) and the torch lifted off the workpiece
just before the end of the cut. This is to prevent the high frequency from
reigniting after cutting arc extinguishes and causing damage to the
nozzle (double arcing).
H. For rapid re-starts, such as grate or heavy mesh cutting, do not release
the torch switch. In the postflow mode, the arc can be re-started
immediately by depressing the torch switch. This avoids the 2-second
preflow portion of the cutting cycle.
HEAT SHIELD
0558003110
NOZZLE
40A 0558002908
90A 0558002837
Fig 3.3 Exploded View of PT-32EH Torch
96
OPERATION
WITH HEAD
ELECTRODE
0558003694
0558001969
VALVE PIN
00558001959
O-RING
SUPPLIED