LENCO SCD-68 DAB+ Benutzerhandbuch Seite 10

Random play

You can listen all tracks in a random order by this function.
CD/MP3 disc programming
Up to 20 tracks can be programmed for disc play in any order. Before use, be sure to press the stop button.
1. Set in CD mode.
2. Press the Memory button (12), "P01 & T000" will appear on LCD display (8).
3. Select a desired track by using the Skip up
4. Press the Memory button (12) to enter the track into the memory.
5. Repeat steps 3 and 4 to enter additional tracks into the memory if necessary.
6. When all the desired tracks have been programmed, press "Play/Pause
order you have programmed.
7. Press "Stop " (10) to terminate the program play.
 Press " Stop " twice (10) at the CD stop mode to cancel all programmed memory until the "Prog"
indicator disappear on LCD display (8).
 For MP3 disc/file, press the "Folder up" button (20) to select the 1
hence to speed up the song selection.
 The programming mode will automatically stop if no button is being pressed in a period of about 30
seconds after pressing the Memory button (12).
Remark:-
MP3 track format requirement:
- Bit rate: 32 kbps~320kbps, sampling rate: 32kHz, 44.1kHz and 48 kHz decodable
-
The performance of playing MP3 disc is various from the quality of the recording disc and the method
of recording. Furthermore, the searching lead-time for MP3-CD is longer than for a 'normal' CD due to
the difference in format.
5.4 Playback of MP3 song via USB storage media
Connecting
The system is able to decode and playback all MP3 files which are stored in the memory media with USB
connecting port.
1. Set the system at Standby mode first or another function except USB mode.
2. Plug-in the USB pen-drive with the face up & make sure it is inserted completely.
Connecting the USB upside down or backwards could damage the audio system or the storage media

(USB thumb driver). Check to be sure the direction is correct before connecting.
3. Turn on the unit again by the On/off button (17) and press the Function button (9) to select the USB
mode. The system will start reading the storage media automatically after connecting, and the LCD
display (8) will show the total number of MP3 files being detected.
4. Repeat the same playback procedure as playing the CD/MP3 disc as above.
Remark
- The system can detect and read files in an MP3 format only at USB mode but not other music file
format.
-
If you connect the system to an MP3 player via the USB socket, due to variances in file system format,
some MP3 players may not be able to play via the USB socket. This is not a malfunction of the system.
- The USB port does not support connection with USB extension cable and is not designed for
communication with computer directly.
-
Due to ErP stage two requirement and protection of the environment (for European market only);
the unit will switch to the standby mode automatically at the moment no music has been playing
over 15 minutes.
Removing the USB
To remove the USB turn off the power or switch the function mode to either cd or tuner mode first. For the
USB port – unplug it by pulling out the USB socket directly.
/Skip down buttons (19/11).
st
" (18) to play the disc in the
track of the next folder directly and
10