Operation - VONROC S2_AG501DC Bersetzung Der Originalbetriebsanleitung

EN
the battery has left.
• When the lights are not burning it means the bat-
tery is empty and must be charged immediately.
Charging the battery with the charger (Fig. C­2)
1. Take the battery (13) from the machine.
2. Turn the battery (13) to upside down position and
slide it onto the charger (17) as shown in Fig. C-2.
3. Push the battery until it is fully pushed into the
slot.
4. Plug the charger plug into an electrical outlet and
wait for a while. The LED indicators on the charger
(18) will lighten up and show the charger status.
The charger has 2 LED indicators (18) which indica­
te the status of the charging process:
Red LED Status Green LED status
Off Off
Off On
On Off
• Fully charging the 2Ah battery may take up to
60 minutes.
• Fully charging the 4Ah battery may take up to
120 minutes.
After the battery is fully charged remove the char-
ger plug from the outlet and remove the battery
from the charger.
When the machine is not being used over a
longer period of time it is best to store the
battery in charged condition.
Assembling the protection guard (Fig. E and F)
1. Place the machine on a table with the spindle
(7) facing upwards.
2. Place the protection guard (3) over the machine
head as shown in Figure E making sure the
ridges on the protection guard fall into the
notches of the machine head.
3. Turn the protection guard counter clockwise as
shown in Figure F and clench the release lever
for protection guard (2).
12
4. You can adjust the position of the protection
guard by releasing the lever (2), adjust the
guard to the desired position and clench the
lever to lock it.
Mounting and removing the wheel disc (Fig. D)
• Always use suitable wheel disc for this machine
with diameter Ø 115 mm and a bore from
22.2 mm the thickness of the wheel disc should
be 6 mm for wheel disc for grinding and 3 mm
for wheel disc for cutting, the mounting wheel
Charger status
disc may not touch the safety guard.
No power
Mounting
Standby mode:
1. Place the machine on a table with the protecti-
- No battery is
on guard (3) facing upwards.
inserted or,
2. Mount the flange (9) onto the spindle (7).
- Battery inserted
3. Place the wheel disc (10) onto the spindle (7).
but charging has
4. Keep the spindle lock button (1) pressed and
finished
firmly tighten the clamping nut (11) onto the
Battery charging in
spindle (7) by using the spanner (12).
progress
Removing
1. Place the machine on a table with the protecti-
on guard (3) facing upwards.
2. Keep the spindle lock button (1) pressed and
loosen the clamping nut (11) using the spanner
(12).
3. Remove the wheel disc (10) from the spindle (7).
4. Keep the spindle lock button (1) pressed and
firmly tighten the clamping nut (11) using the
spanner (12).
Mounting the side handle (Fig. A and G)
• The side handle (8) can be screwed into one of
the three side handle connection points (6).

4. OPERATION

Switching on and off (Fig. B)
• To switch on the machine in continuous mode,
slide the on/off switch (5) to the right and slide
Do not use the machine without the guard.
Only use sharp and undamaged wheel
discs.
Make sure that the work piece is properly
supported or fixed.
WWW.VONROC.COM