Accessories; Repairs; Environmental Protection; Technical Specifications - Metabo BE 710 Gebrauchsanleitung

170267550_0208 BE 710.book Seite 15 Donnerstag, 31. Januar 2008 10:45 10
Slow flashing - carbon brushes worn
The carbon brushes are almost completely worn.
If the brushes are completely worn, the machine
switches off automatically. Have the brushes
replaced by an authorized service centre.
Permanently lit - overload
If the machine is subject to long periods of conti-
nuous overloading, the power input of the machine
is limited. This prevents the further unauthorized
heating of the motor.

12 Accessories

Use only genuine Metabo accessories.
If you need any accessories, check with your
dealer.
For the dealer to select the correct accessory, he
needs to know the exact model designation of your
power tool.
See page 4.
A Metabox
B Angle drilling and screwdriving attachment
C Flexible shaft
D Rubber backing pad
E Linen-backed sanding discs
F Drill stand (drill clamp can be rotated 360°.)
G Moulding and drill stand (column with toothed
rack and guide groove)
H Machine vice
I Fitting bit spring
J Steel-wire end brush
K Steel-wire cup brush
L Steel-wire wheel brush
For complete range of accessories, see
www.metabo.com or the main catalogue.

13 Repairs

Repairs to electrical tools must be carried out by
qualified electricians ONLY!
Any Metabo power tool in need of repair can be
sent to one of the addresses listed in the spare
parts list.
Please attach a description of the fault to the power
tool.

14 Environmental Protection

Metabo's packaging can be 100% recycled.
Worn out power tools and accessories contain
considerable amounts of valuable raw and plastic
materials, which can be recycled.
These instructions are printed on chlorine-free
bleached paper.
Only for EU countries: Never dispose of
power tools in your household waste! In
accordance with European Guideline
2002/96/EC on used electronic and electric
equipment and its implementation in national legal
systems, used power tools must be collected sepa-
rately and handed in for environmentally compat-
ible recycling.

15 Technical Specifications

Explanatory notes on the information on page 2.
Changes due to technological progress reserved.
P = rated power consumption
1
P = power output
2
n = no-load speed
1
n = load speed
2
ø max = max. solid drill diameter
b = chuck capacity
G = spindle thread
H = spindle with hexagon socket
m = weight
D = spindle collar diameter
Vibration total value (vector sum of three
directions) determined in accordance with
EN 60745:
a = Vibration emission value
h, D
(drilling into metal)
K = Unsafe (vibration)
h, D
The vibration emission level given in this informa-
tion sheet has been measured in accordance with
a standardised test given in EN 60745 and may be
used to compare one tool with another. It may be
used for a preliminary assessment of exposure.
The declared vibration emission level represents
the main applications of the tool. However if the tool
is used for different applications, with different
accessories or poorly maintained, the vibration
emission may differ. This may significantly increase
the exposure level over the total working period.
An estimation of the level of exposure to vibration
should also take into account the times when the
tool is switched off or when it is running but not
actually doing the job. This may significantly reduce
the exposure level over the total working period.
Identify additional safety measures to protect the
operator from the effects of vibration such as:
maintain the tool and the accessories, keep the
hands warm, organisation of work patterns.
Typical A-effective perceived sound levels:
L = Sound pressure level
pA
L = Acoustic power level
WA
K , K = Unsafe (noise level)
pA WA
ENGLISH
ENG
15