Resetting All Remote Control Codes - Yamaha RX-V765 Bedienungsanleitung

Clearing the assignment of each key
You can clear the assignment of each key.
1
Press oCODE SET on the remote control
using a pointed object such as the tip of a
ballpoint pen.
cTRANSMIT on the remote control blinks twice.
2
Press eInput selection keys to select the
input source whose assigned function you
want to reset.
3
Enter "9991" using mNumeric keys.
4
Press the key that you want to reset.
The assignment to that key is cleared. When the
assignment is cleared successfully, cTRANSMIT
on the remote control blinks twice.
If it fails, cTRANSMIT blinks six times. Repeat
from step 1.
y
• To continue resetting other keys, repeat step 4.
5
To end the reset operation, press oCODE
SET on the remote control using a pointed
object such as the tip of a ballpoint pen.
cTRANSMIT on the remote control blinks once.
Clearing the assignments of all keys
You can clear the assignments of all the keys in one go.
1
Press oCODE SET on the remote control
using a pointed object such as the tip of a
ballpoint pen.
cTRANSMIT on the remote control blinks twice.
2
Press eInput selection keys to select the
input source, the function of which is
assigned to the key that you want to reset.
3
Enter "9992" using mNumeric keys.
The assignments of all key are cleared. When the
assignments are cleared successfully,
cTRANSMIT on the remote control blinks twice.
If it fails, cTRANSMIT blinks six times. Repeat
from step 1.
y
• When you initialize the remote control code (see the next section), the
assignments of all the keys are cleared.
Controlling other components with the remote control

Resetting all remote control codes

You can clear all the remote control codes previously set,
and reset all of them to the initial factory settings.
y
• Each of the steps described in this section should be performed within
one minute. Setting operation is automatically canceled when one minute
has passed since the last step. If the operation is cancelled, start again
from the beginning.
1
Press oCODE SET on the remote control
using a pointed object such as a tip of a
ballpoint pen.
cTRANSMIT on the remote control blinks twice.
2
Press jSETUP on the remote control.
3
Enter "9981" using mNumeric keys.
Once the initialization is complete, cTRANSMIT
on the remote control blinks twice. If it fails,
cTRANSMIT blinks six times. Repeat from
step 1.
57
En