Before You Start The Device - Silvercrest SKWH 2000 A1 Bedienungs- Und Sicherheitshinweise

aged or leaking batteries,
exercise a particular caution.
Risk of chemical burns! Wear
protective gloves.
Chemicals escaping from a bat-
Q
tery can cause skin irritation.
In case of contact with skin,
Q
rinse with much water. In case
of contact with eyes, do not rub
your eye, but rinse it with water
and immediately visit a doctor .
Never let the batteries get into
Q
the hands of children. If a small
child puts a battery into his
mouth, he can swallow it. If the
battery is swallowed, call a doc-
tor immediately.
Never use different battery
Q
types together.
When inserting the battery, pay
Q
especial attention to the correct
polarity. Wrong polarity can
cause risk of bursting.
If you do not use the device for
Q
a long time, remove the batter-
ies from the device.

Before you start the device


REMOTE CONTROL:
HOW TO INSERT OR CHANGE THE BATTERY
The remote control unit is delivered together with a lit-
hium button cell. To enable the remote control, remove
the plastic tape that protrudes from the battery compart-
ment (see Figure 1).
13
1
If the remote control battery needs to be replaced, in-
sert a new 3-volt lithium button cell. Pay attention to the
type of lithium button cell (CR2025).
2
Press the tab on the battery compartment
12
of the remote control toward the centre. Now pull
out the battery compartment
Remove the old battery.
Insert a new 3V-button-cell battery (type CR2025).
Pay attention to the correct polarity.
Push the battery compartment
mote control unit until the tab
13
. (see Figure 2).
13
back into the re-
13
snaps into place.
12
GB/IE/NI/CY 11