Cosmo CLASSIC Installations-, Bedienungs- Und Gebrauchsanweisung Seite 23

Press for at least 2 seconds to copy the program for the current day onto the next
day. After five seconds of inactivity, the program goes back to the CLOCK function
.
If, during the time setting and weekly program, the ON/Stand-by button is
pressed, the controller goes into stand-by state, saving the new timing/date while the
new weekly program is not saved. With a new pressing on the ON/Stand-by button
, the controller goes into ON state into the mode that was present before the time
setting.
In case of 230 Vac supply power cut off, the chrono weekly program, the high and
low temperature are retained into the memory, instead the current time is lost. After
the 230Vac power supply comes back, if chrono mode is selected, the symbol
and the display writing time flickers: in that case following the procedure described at
the beginning of the paragraph it is possible to set the time. Until the operation is not
performed, controller temporarily counts the time from the moment when the power
supply 230Vac has become available again (and this "temporary" time is used in
case you selects the chrono mode).
LOCK FUNCTION
Press and simultaneously for at least two seconds to enable or disable key
lock.
With the loocking function active is still possible to put the regulator in stand-by state
or in ON state pushing the ON/Stand-by button , but it is not possible to change
setting or mode.
10