Controller Operation - Cosmo CLASSIC Installations-, Bedienungs- Und Gebrauchsanweisung

3. Delicately remove the wires from the hole in the top of controller and connect
them to the electric heating element. For class I product connect the cylindrical
contact on the yellow-green wire to the heating element pin.
Connect the red wires, which are interchangeable, to the flat contacts (Fig. 5).
SUPPLIED O-RING
4. Fit controller to the connection on the electric heating element (Fig. 6),
pressing the controller until it is fully inserted and the supplied O- RING fully
compressed.
Make sure the wires go all the way into the controller and do not stick in the
first part of the hole.
5. Tighten the hex screw keeping the controller pressed to the heating element;
Be sure to keep the supplied O- RING fully compressed during the operation
(Fig.6).
The hex screw must disappear to the edge of the plastic. Close until it lock.
6. Check that the controller is securely fixed to heating element (Fig.7).
Connect the controller supply cord to the mains according to the standards
and regulations in force in the country where installation is carried out.
The controller Cosmo Classic has four buttons and a display (Fig. 8). ON/Stand-by
button switches the regulator ON or puts it on standby: when controller is on standby,
the display shows a flashing dot while when it is ON the display shows time and
program in the chrono mode or the temperature setting in the other modes.
Fig. 6

CONTROLLER OPERATION

6
Fig. 7