M-system MFTW120IX Gebrauchsanleitung Seite 87

CONVERSIONS
REPLACING THE INJECTORS
Our burners can be adapted to different types of
gas by simply installing the injectors suitable for
the gas you want to use. To help the installer, in the
table <TECHNICAL FEATURES> paragraph,gives
the burner nominal heat input, injector diameter and
operating pressure of the different gas types.
Comply with the following instructions:
Injector replacement - Hob burners.
To change the injectors on the hob, remove the burner
cup and head and with a 7 mm Ø socket spanner
replace them (fig.22).
After having replaced the injectors, it will be
necessary to proceed with burner adjustment
as explained in the previous paragraphs. The
technician must replace any seals after the
adjustments have been made.
CHANGING THE FLEXIBLE GAS HOSE
In order to guarantee that the gas hose is always in
excellent condition we strongly recommend changing
it on the date you will find printed on it.
INSTRUCTIONS FOR THE INSTALLER
22
REPLACING THE ELECTRICAL COMPONENTS
• The rear protection will have to be removed in order
to change the electrical heating elements, lamp
holder, terminal board and power cable.
• If you have to change the power cable, always
keep the earth wire longer than the phase wires
and, in addition, follow all the instructions given
in the "ELECTRICAL CONNECTION" paragraph.
• To replace the oven lamp please refer to instructions
on REPLACING THE OVEN LAMP paragraph.
• To change the lamp-holder (P), type 1, force the
tabs of blockage (M) and take the lamp-holder
toward the outside of the oven.
• To change lamp holder (P), type 2, use a screwdriver
to push the clamp tips (fig. 23) and pull the lamp
holder out towards the inside of the oven.
• To replace the ignition generator, remove the left
side panel of the appliance.
• To change the thermostat, commutators or hob
heating elements, the work top has to be removed.
P
26
M
23