AEG LP 2252 F Benutzerinformation Seite 23

Problem
The machine does not fill:
The machine fills then empties immediately:
The machine does not empty and/or does not
spin:
There is water on the floor:
Possible cause/Solution
The water tap is closed.
• Open the water tap.
The inlet hose is squashed or kinked.
• Check the inlet hose connection.
The filter in the inlet hose or the inlet valve fil-
ter are blocked.
• Clean the water inlet filters. (See "Cleaning
the water inlet filters" for more details)
The door is not properly closed.
• Close firmly the door.
The end of the drain hose is too low.
• Refer to relevant paragraph in «Water drain-
age» section.
The drain hose is squashed or kinked.
• Check the drain hose connection.
The drain filter is clogged.
• Clean the drain filter.
An option or a programme that ends with the
water still in the tub or a that eliminates all the
spinning phases has been selected.
• Disable the option.
• Select the draining or the spinning pro-
gramme.
The laundry is not evenly distributed in the
drum.
• Redistribute the laundry.
Too much detergent or unsuitable detergent
(creates too much foam) has been used.
• Reduce the detergent quantity or use anoth-
er one.
Check whether there are any leaks from one of
the inlet hose fittings. It is not always easy to
see this as the water runs down the hose; check
to see if it is damp.
• Check the water inlet hose connection.
The drain hose is damaged.
• Change it with a new one.
The cap on the filter has not been replaced or
the filter has not been properly screwed in after
cleaning action.
• Put the cap back on the filter or screw the
filter fully in.
23
What to do if...