Interrupting A Programme; Cancelling A Programme; Opening The Door After The Programme Has Started; At The End Of The Programme - AEG LP 2252 F Benutzerinformation

Interrupting a programme

Press the button 7 to interrupt a programme which is running, the corresponding light
starts blinking. Press the button again to restart the programme.

Cancelling a programme

Turn the selector dial to
new programme.

Opening the door after the programme has started

First set the machine to pause by pressing the button 7. If, after some minutes the light 8.2
goes off, the door can be opened.
If the door remains locked - the pilot light 8.2 is on, this means that the machine is already
heating or that the water level is too high. In this case the door can not be opened.
If you cannot open the door but you need to open it you have to switch the machine off by
turning the selector dial to
to the water level and temperature !) .
After you closed the door, select the programme and options again. Press button 7 to start
the programme.

At the end of the programme

The machine stops automatically. The light of button 7, the lights 8.1 and 8.2 go off. A
blinking will appear on the display. Some acoustic signals sound. The door can be opened.
If you have set a programme or an option that ends with water still in the tub, a blinking
will appear on the display. The pilot light of button 7 goes off. The light 8.2 illuminates. The
door remains locked. The water must be emptied out before opening the door. During this
time the drum continues to turn at regular intervals until water drain.
Follow the below instructions to empty out the water:
• Turn the programme selector dial to
• Select the draining or spinning programme
• Reduce the spin speed, if needed, by pressing the relevant button
• Press button 7 to start the programme
• When the programme has finished the display shows a blinking
goes off . The door can now be opened.
Turn the programme selector dial to the position
laundry from the drum and carefully check that the drum is empty. If you do not intend to
carry out another wash, close the water tap. Leave the door open to prevent the formation
of mildew and unpleasant smells.
Stand by : once the programme has finished after a few minutes the energy saving system
will be enabled. The brightness of the display is reduced. By pressing any button the appli-
ance will come out of the energy saving status.
to cancel a programme which is running. Now you can select a
. After some minutes the door can be opened (pay attention
. The pilot light 8.2
to switch the machine off. Remove the
13