Operating Elements; Operation - Abicor Binzel ABITIG Little SL Betriebsanleitung

5 Operating elements

5 Operating elements
NOTICE
• Only qualified personnel are permitted to perform work on the device or system.
• Consult the documentation for the welding components.
Using a standard welding torch, the two-cycle mode of the trigger can be activated.
5.1 2-cycle function of the trigger
1 Press the Single function trigger on the handle and keep it depressed = welding is started.
2 Release the trigger = welding is stopped.

6 Operation

WARNING
Electric shock
Equipment parts are energized during welding.
• Keep your hands out of the danger zone.
1 Open the shielding gas cylinder.
2 Start the welding process.
3 After ignition, hold the welding arc tight to the edge of the material to be welded until a
molten pool is formed.
4 Move the torch uniformly over the entire seam length.
5 Stop the welding process.
6 After switching off, hold the torch over the end position for a few seconds. This allows the
molten pool to solidify without atmospheric interference under the protection of the gas
which is continuing to flow.
EN - 10
®
ABITIG Little SL
BAL.0285.0 • 2019-06-19