Assemble Mounting Brackets - Only For Incomplete Machines; Screw Tightening Torque - Speck-Pumpen IN-VB Originalbetriebsanleitung

Maintenance
Cartridge Seal
Fig. 19
8.6.6 Assemble mounting brackets – only for incomplete machines
 Observe figure 14.
1. Place the mounting brackets (89-11.03) in the drive lantern (161) from above.
2. Assemble both coupling halves (849) on the shaft (211). The mounting bracket (89-11.03) should lie
between the coupling halves (849).
3. Tighten the hexagon socket screws (914.1).
4. Assemble the coupling guard (681) on the drive shaft (161) using the hexagon socket screws
(914.2).
8.7

Screw tightening torque

 Observe the following torque values during assembly. See point 10.2 on page 44
Part no.
800
903.1
903.2
914.1
901.1
914.3
922
920.1
34 EN
MIN + 1.5 mm
MIN
Description
Motor
Screwed plug
Screwed plug
Hexagon socket screw
Hexagon socket screw
Hexagon socket screw
Nut
Nut
WG56.00.011-P
Thread Starting torque [Nm]
M6 10
M12 70
M16 70
R 3/8 15
R 1/4 until IN-VB 25: 15 Nm
from IN-VB 40: 10 Nm
M6 St 16
M8 St/GG 30
M8 Al 22
M10 70
M6 10
M8 10
M10 50
M12 70
M16 70
M5 4
M6 10
M8 10
M10 28
M12 50
M8 12
M10 20
M12 25
M16 50
11|2018