Leica DMI3000B Bedienungsanleitung Seite 69

Function Buttons on the Front Panel (Fig. 87)
100% of the light goes to the eye piece
(87.1).
Toggle function for the side ports
→
(87.2). This function depends on the
individual microscope confi guration.
Note:
Switching to the bottom port:
via the variable function buttons (Lei-
ca DMI6000 B only), switching to top
port: manually.
SHUTTER Opens and closes the shutter (87.3).
Switches
→
mag nifi cations of the magnifi cation
changer (87.4).
The magnifi cation changer is set to
1x
the magnifi cation 1x (87.5).
Fig. 87 Front control panel
1 100% light to eyepiece
2 Toggle ports
3 Shutter
4 Switch between subsequent magnifi cations
5 Subsequent magnifi cation 1x
6 Selecting fi lter cubes
1 2
6
between the possible
3 4 5
6
CUBE The CUBE 1 to CUBE 6 (87.6) buttons
permit the direct selection of indi-
vidual fi lter cubes, provided the se-
lected cube is valid for the selected
method.
Press the CUBE 3 and CUBE 4 but-
tons at the same time to display the
assignments of the variable function
buttons. To reset the display, press
the buttons again or wait 3 seconds.
Focus buttons (Fig. 88) (DMI6000 B only)
Z ↑
Moves the Z drive in the indicated di-
Z ↓
rection.
Sets the upper focus stop.
SET + Z ↑
SET + Z ↓ Sets the lower stop.
Fig. 88
1 Focus control buttons
2 Open fi lter drawer
2
1
7. Start-up
69