Use; Switching On / Off / Selecting The Temperature; Temperature Settings; Automatic Switch-Off - Silvercrest FW 10 Handbuch

Use

Note: The foot warmer may give off an odour of
plastic on first use. This odour will cease to develop
after a short while.
Switching on / off / Selecting
the temperature
Insert the mains plug into the mains socket.
Switching on:
Set the control unit
or 6 to switch on the foot warmer.
Note: The function indicator
the foot warmer is switched on.
Note: This foot warmer has a rapid heat-up
feature, which will cause the foot warmer to
warm up quickly within the first 15 minutes.
Switching off:
Set the control unit
the foot warmer.
Note: The function indicator
Selecting the temperature:
Just before using the foot warmer, set it to the
highest temperature setting (setting 6). This will
cause the foot warmer to warm up quickly.
If you are going to use the foot warmer for a
number of hours, set it to the lowest temperature
setting (setting 1).
The foot warmer can, of course, also be used at
any time if it is switched off. Its fur-fabric luxury
is warm in the event that a convenient electrical
socket is not available.

Temperature settings

Using the control unit
the desired temperature setting.
Setting 0: Off
Setting 1: Minimum heat
67225_silv_Fußwaermer_Content_LB3.indd 9
to setting 1, 2, 3, 4, 5
2
illuminates after
3
to setting 0 to switch off
2
ceases to illuminate.
3
set the temperature to
2
Use / Cleaning and care
Settings 2–5: Customised heat
Setting 6: Maximum heat

Automatic switch-off

Note: The foot warmer switches itself off automati-
cally after about 90 minutes. The function indicator
then starts to flash.
Then select the setting 0 and after about 5
seconds, reset the foot warmer to the desired
temperature setting to switch it on again.
Switch the foot warmer off (setting 0) and pull
the mains plug out of the mains socket if the
foot warmer is not to be used after it has
switched itself off automatically.

Cleaning and care

Keep the foot warmer clean as it cannot be
washed.
FROM ELECTRIC SHOCK! Before
cleaning the foot warmer always
remove the plug from the mains socket.
Small stains can be removed with a cloth or
moist sponge and if necessary with a little mild
detergent. The foot warmer must not become
soaked through when doing this.
Please note that the foot warmer must not be
machine-washed, spun or dried, chemically
cleaned, wrung out, put through a mangle or
ironed.
The removable fur-fabric lining
washed by hand.
RISK OF ELECTRIC SHOCK!
RISK OF DAMAGE TO THE
PRODUCT! Use the foot warmer
again only after the foot warmer and the fur-fabric
liner are completely dry.
1
3
RISK TO LIFE
can be
1
GB/IE 9
04.05.11 10:17