Bionaire BT05RC Benutzerhandbuch Seite 3

BT05RCIQ03M1 visual.qxd 2/12/04 9:06 AM Page 7
FITTING A REPLACEMENT PLUG (UK
U.K. and IRELAND
ONLY)
The wires in this mains lead are coloured in
PLEASE READ AND SAVE THESE
accordance with the following code:
INSTRUCTIONS
Blue
IMPORTANT INSTRUCTIONS
Brown
When using electrical appliances, basic safety
This appliance is fitted with a 13 amp plug.
precautions should always be taken including
The fuse should be rated at 3 amps and ASTA
the following:-
approved to BS1362.
• Use the fan only for purposes described in
However if the plug is unsuitable, it should be
the instruction manual.
removed from the supply cord and an
• To protect against electrical shock, do not
appropriate plug fitted as detailed below:-
immerse the fan, plug or cord in water or
spray with liquids. As the colours of the wires in the mains lead of
• Close supervision is necessary when any this appliance may not correspond with the
appliance is used by or near children. coloured markings identifying the terminals in
• Unplug from the electrical outlet when not in your plug, proceed as follows:-
use, when moving the fan from one location
The wire which is coloured Blue must be
to another, before putting on or taking off
connected to the terminal which is marked with
parts and before cleaning.
the letter N or coloured Black.
• Avoid contact with any moving parts.
The wire which is coloured Brown must be
• Do not operate in the presence of explosive
connected to the terminal which is marked with
and/or flammable fumes.
the letter L or coloured Red.
• Do not place the fan or any parts near an
open flame, cooking or other heating NB. Neither wire should be connected to the
appliance. terminal in your plug which is marked with the
• Do not operate any appliance with a damaged letter E or by the Earth symbol
cord, plug, after the appliance malfunctions, Green or Green and Yellow. If in doubt consult a
or has been dropped/damaged in any qualified electrician.
manner.
If any other plug is used, a 3 amp fuse must be
• The use of attachments not recommended or
fitted either in the plug or adaptor or at the
sold by the appliance manufacturer may
distribution board.
cause hazards.
• Do not use outdoors.
• Do not let the cord hang over the edge of a
table or counter, or come into contact with hot
surfaces.
• To disconnect from the electrical supply, grip
the plug and pull from the wall outlet. DO
ASSEMBLY INSTRUCTIONS (See Fig 1.)
NOT pull on the cord.
1. Remove all contents from the box, being careful
• Always use on a dry, level surface.
not to discard any parts required for assembly.
• The fan should not be operated without its
2. Pass the power cable (1) through the slot (2)
base fitted.
in the rear base (3).
• The fan should not be operated laying on its
3. Push the rear base into the front base (4) and
side.
snap together.
• This product is intended for household use
4. Insert the fan body (5) into the assembled base
ONLY and not for commercial or industrial
(from step 3) taking care to ensure the power
applications.
cable is not trapped. Turn the fan upside down
• Should the fan stop working, first check the
and insert the 2 butterfly screws (6). Turn
fuse in the plug (UK only) or fuse/circuit breaker
clockwise to tighten.
at the distribution board is operating, before
5. Pass the power cable over pillar (7) of the
contacting the manufacturer or service agent.
assembled base and ensure that the power
• If the supply cord or plug is damaged, it must
cable lies flat in the groove in the rear base.
be replaced by the manufacturer or its service
Make sure the power cable is fixed securely,
agent or a similarly qualified person in order
by using the cord grip (8) (See Fig 2).
to avoid hazard.
2
OPERATING INSTRUCTIONS
IMPORTANT:
REMOTE CONTROL
The Remote Control requires 2 AAA batteries
for operation.To install the batteries, simply
- Neutral
depress the back of the remote, with your thumb
- Live
in the indentations, and remove the cover. Insert
the batteries according to the diagram shown
inside. Replace the cover.
Operating
1. Set the fan base on a dry level surface.
2. Plug the cord into a suitable 230-240V. AC
outlet.
3. Turn the fan on by pressing the 0/OFF
LED light on the front of the fan will illuminate.
Turn the fan Off by pressing the 0/OFF
button. Pressing the 0/OFF
button will
automatically clear all settings and reset the fan.
4. The speed is adjusted by repeatedly pressing
the Speed Button - I II III -
on the remote
control or on the control panel.
I = low speed
II = medium speed
III = high speed
The appropriate LED light on the front of the
fan will illuminate.
or coloured
ADJUSTMENT
Oscillation control (See Fig.3/4)
To start and stop oscillation of the fan head, push
the Oscillation Button on the remote control or
on the control panel.
Air direction set manually
With the Oscillation Button off, the air direction
angle can be set in five horizontal positions by
manually turning the fan body until the fan 'clicks'
into the desired position.
Timer control (See Fig.3/4)
To start and stop the timer, press the Timer Button
on the remote conrol or control panel to cycle
through the timer settings.
The appropriate LED light on the front of the fan
will illuminate.
Natural breeze movement/ Sleep control
(See Fig.3/4)
1. For a natural breeze movement, push the Breeze
Button once. This will automatically vary
the fan speeds faster and slower.
2. Push the button again to activate the
sleep control. This function slows the fan speed
down and when used in conjunction with the
timer settings will gradually slow the fan down
and switch off. E.g. SLEEP + 4hrs TIMER
programmes the fan to gradually slow down
over the 4 hours and eventually turn off.
3. Push the button a 3rd time to switch off
the BREEZE and SLEEP functions.
The appropriate LED light on the front of the fan
will illuminate when the Breeze function is selected.
CLEANING AND MAINTENANCE
Follow these instructions to correctly and safely
care for your Bionaire fan. Please remember:-
• Always unplug the fan before cleaning or
assembly.
• Do not allow water to drip on or into the fan
motor housing.
• Be sure to use a soft cloth, moistened with a
mild soap solution.
• Do not use any of the following as a cleaner:
petrol, thinners or benzine.
The Holmes Group reserves the right to change
or modify any specifications without notice.
THIS PRODUCT IS MANUFACTURED TO
COMPLY WITH THE E.E.C. DIRECTIVES
73/23/EEC, 89/336/EEC and 98/37/EEC.
GUARANTEE
PLEASE KEEP YOUR RECEIPT AS THIS WILL
BE REQUIRED FOR ANY CLAIMS UNDER THIS
GUARANTEE.
• This product is guaranteed for 3 years.
• In the unlikely event of breakdown, please
take it back to the place of purchase, with
your till receipt and a copy of this guarantee.
• The rights and benefits under this guarantee
are additional to your statutory rights which
are not affected by this guarantee.
• Holmes Products Europe undertakes within the
specific period, to repair or replace free of charge,
any part of the appliance found to be defective
provided that:
• We are promptly informed of the defect.
• The appliance has not been altered in any way
or subjected to misuse or repair by a person
other than a person authorised by Holmes
Products Europe.
• No rights are given under this guarantee to a
person acquiring the appliance second hand
or for commercial or communal uses.
• Any repaired or replaced appliance will be
guaranteed on these terms for the remaining
portion of the guarantee.
3