Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
f the
o n raft is e
9. For external motors, connect the motor unit
otor connect the
cable to the relevant connector on the elec-
s eci c ter inal boar fo n on the lastic
trical components box.
bo sho n in ig
10. Power the cookerhood.
HOW TO USE THE COOKER HOOD
This appliance is intended to suck cooking
fumes, greases and steam. It has been designed
to work in both suctioning mode, with outside
evacuation, and filtering mode.
Outside - discharge version
The cooker hood can be mounted in the version
with outside discharge of suctioned air: in this
case it is necessary to connect the exhausting
channel to the outside (exhausting pipes are not
supplied with the products.)
Non-return valve blockage
WARNING
Before connecting the air exhaust hose,
make sure that the non-return valves can
rotate freely.
In case of outside air discharge installation, fit a
non-return valve to prevent wind and back air
from entering.
18
i
e
ith e ternal
otor nit cable to the
EN
Filtering mode
In case fumes and vapour cannot be evacuated
outside, the appliance can be used in the filtering
mode.
Activated charcoal filters are required for this
type of cooker hood.
Air recycled through the charcoal filters is recir-
culated into the kitchen, thanks to a duct con-
veying the air on one side of the cabinet (Fig.
CAUTION
Installation must comply with the regula-
tions in force regarding the ventilation of
enclosed environments. In particular, dis-
charged air must not be conveyed into a
duct used for fumes discharge or discharge
from appliances using gas
or other combustible materials. The use of
discontinued ducts is not allowed without
the approval of a qualified technician.
REMOVING
GREASE
MOUNTING
THE
MOUNTING THE ACTIVATED CHAR-
COAL FILTER
COAL FILTER
he re o al an
an the charcoal lter shall be carrie o t
The removal and fitting of the grease and carbon
the
o n raft o en
filters need to be carried out with the downdraft in
sh the glass o n ar s so as to
the open position. To open the downdraft, push
o ening of the a
the
key. Then remove the front panel, push-
e the
etal grease lters
ing the upper part of each side at the same time.
call sec re to the a
The panel will rotate forwards to make it possible
a han tool or a nife e ge
to access the grease filters (Fig. 6). Remove the
in the lter si es as sho n in ig
grease filters to access the carbon filters (Fig.
ternati e
o can re o e the
12). The replacement of the charcoal filters has
sh the lters fro
to be carried out accordingly to the effective use
lters into their seat b bringing the
of the Downdraft, and in any case at least once
the
agnets ntil the
every 6 months.
he charcoal lter is installe
ase lter rear si e
WARNING
shall be re lace
After having replaced the filters, reinstall the
se of the
o n raft an in an case at least
front stainless steel pan'el, otherwise the
once e er
onths
Downdraft is not enabled to function.
THE
GREASE
FILTER
REMOVAL,
ACTIVATED
tting of both the grease lter
o o en the
liance easier
ig
hich are
liance b
sing either
ct in the slot fo n
er glass an
the insi e to o tsi e
ee the
into lace
irectl on the gre
see ig
harcoal lters
accor ingl to the effecti e
S-DD2-L FLUSH TOP
FILTER,
CHAR-
ith
o n raft
a e the
e o
pull
agneti
s an al
it the
close to
Werbung
Kapitel
Inhaltsverzeichnis
