DT SWISS D 232 Bedienungsanleitung Seite 16

3. ASSEMBLY
DANGER
Risk of accident caused by damage resulting from add-on parts with sharp edges!
Installing parts with sharp edges can damage the seat post.
• Make sure that the seat tube clamp, the seat tube of the bike frame, and any reduction shim
used do not have sharp edges.
3.1 ATTACHING THE REMOTE LEVER TO THE HANDLEBARS
1. Using a 3 mm hex key loosen the fixing screw
on the clamp and attach the remote lever on
the desired side of the handlebars.
2. Tighten the fixing screw with a max. tightening
torque of 5 Nm.
→ If the remote lever is fitted on carbon handlebars,
the maximum torque may be lower. Observe the handlebar
manufacturer's user manual!
3.2 MANUALLY EXTENDING THE SEAT POST
The seat post is delivered in compressed condition. Before fitting, the seat post must be extended
manually.
CAUTION
Risk of injury due to the seat post moving out abruptly!
After manually actuating the quickconnector, the upper
part of the seat post moves out abruptly.
• Keep parts of the body, and your head, clear of the
seat post stroke area!
1. Hold the seat post with one hand on the seat tube (as
shown), and pull the quickconnector down with your
other hand.
→ The locking system is unlocked and the seat post
moves out.
16