Section 4 Operation; Steel Heat Shield Guards - ESAB PT-32EH Bedienungsanleitung

sEctIoN 4
4.1 stEEl hEat shIElD guarDs (refer to figure 4-1)
Drag cutting with the pt-32Eh torch
If drag cutting is desired, attach ESAB's standoff guide (P/N 0558002393). For thin material, under 3/8" (9mm), remove 50-70
amp or 90 amp nozzle from torch head, insert ESAB's 40 amp nozzle (P/N 0558002908). Lower current level to 40 amps or
lower.
ADJUST GUIDE BY TURNING IN A CLOCKWISE
DIRECTION ONLY. THIS WILL PREVENT AC-
CIDENTAL LOOSENING OF SHIELD.
STEEL GUARD
STAND OFF GUIDE
P/N 0558002393
GUIDE AGAINST
STRAIGHT EDGE
OR FREE-HAND
CUT
figure 4-1. Installation and operation of steel heat shield guards
Drag cutting, even with lower current levels may significantly
reduce the life of torch consumables. attempting to Drag
cut with higher currents (70 amps) may cause immediate
catastrophic consumable damage.
IF GUIDE IS TOO TIGHT ON
SHIELD, OPEN SLOT WITH
SCREWDRIVER.
3/16" (4.7 mm)
TORCH-TO-WORK
75
opEratIoN
NotIcE
IF TOO LOOSE, CLOSE
SLOT WITH VISE OR
LARGE PLIERS.