Block Function; Filter-Holders - LaCimbali M39 Dosatron TE Gebrauch Und Installation

When the machine is blocked, a warning message appears
on the display: if the key corresponding to the requested wash
cycle is pressed (key 26) and the instructions on the display
are followed, the wash cycle is performed and the machine is
no longer blocked.
For example, if there is a "coffee block", the following message
appears on the display:
GROUP 1 LOCKED
EXECUTE WASHING
The number of the "blocked group" blinks on the display and
depends upon the number of machine groups.
CHanGInG THE WaTER In THE BoILER - Procedure to carry out at least once a day
Keep a hot water distributor key (12) pressed down for
approximately 5 seconds.
The following message will be displayed: "WATER ChANGE".
The water from the boiler will drain from the hot water nozzle
(8) (60 - 70% ca. of the total capacity).
Dispensing will stop automatically.
After the procedure, the machine will return to its normal
functions and the boiler will be refilled with fresch water.
FILTER-HoLDERS - This operation must be made on all the filter-holders at the end of each working day
1
Put a liter of cold water in a
suitable container and add
detergent.
4
Remove any residue with a sponge and rinse well with cold
water.

Block function

2
Remove the filters from the filter-holders.
If the coffee wash circuit key
message will be integrated as shown:
GROUP 1 LOCKED
EXECUTE WASHING
INSERT FILTER HOLDER
When the "INSERT FILTER HOLDER - GROUP 1" message
appears, the block message for Group 1 disappears. The
block messages for groups still to be washed appear in al-
ternation.
At this point, follow the steps on the previous pages for the
wash cycle.
12
8
5
a
Place the filters back in the filter holder, making sure that the
anchoring spring (a) of the filter is in its slot.
62
(26) is pressed, the previous
GROUP 1
12
3
Soak the filters and the filter-
holders in this solution for
about 2 hours.