Ec Declaration Of Conformity - DeVilbiss JGA Serie Bedienungsanleitung

E
E
Read and follow all instructions and Safety Precautions before using this
The JGA Suction Feed Spraygun Kit is approved to ATEX regulations 94/9/EC, protection level;
Important: These Sprayguns are suitable for use with most solvent based coating materials.
Nozzles and Needles are manufactured in Stainless Steel. These guns are not designed for use
with highly corrosive and/or abrasive materials and if used with such materials it must be expected
that the need for cleaning and/or replacement of parts will be increased. If there is any doubt
regarding the suitability of a specific material contact your local Distributor or ITW Finishing direct.
Model Part Number
Example:
JGA-S186-14
Aircap No

EC Declaration of Conformity

We: ITW Finishing UK, Ringwood Rd, Bournemouth, Dorset, BH11 9LH, UK, as the
manufacturer of the Spraygun model JGA, declare, under our sole responsibility, that the
equipment to which this document relates is in conformity with the following standards or other
normative documents:
BS EN 292-1 PARTS 1 & 2: 1991, BS EN 1953: 1999; and thereby conform to the
protection requirements of Council Directive 89/392/EEC relating to Machinery Safety Directive,
and;
EN 13463-1:2001, council Directive 94/9/EC relating to Equipment and Protective
Systems intended for use in Potentially Explosive Atmospheres protection level II 2 G.
ITW Finishing Systems and Products reserve the right to modify equipment specification without prior notice.
© 2003 ITW Finishing Systems and Products
Operation Manual
JGA – Suction Feed Spraygun
Important
Description
II 2 G X, Suitable for use in Zones 1, and 2
Fluid Tip Size
equipment
Example:
Kit Number
Fluid Tip Size
B. Holt, General Manager
30th June 2003
2
Model Part Number
JGA-694FWH-186
Aircap No