Mounting The Camera; Tools Required - Dometic CAM 200 Montage- Und Bedienungsanleitung

CAM200
7

Mounting the camera

7.1

Tools required

For installation and assembly you will require the following tools:
Drill bit set (fig. 1 1, page 2)
•
Drill (fig. 1 2, page 2)
•
Screwdriver (fig. 1 3, page 2)
•
Set of ring or open-ended spanners (fig. 1 4, page 2)
•
Measuring ruler (fig. 1 5, page 2)
•
Hammer (fig. 1 6, page 2)
•
Centre punch (fig. 1 7, page 2)
•
To make and test the electrical connection, the following tools are required:
Diode test lamp (fig. 1 8, page 2) or voltmeter (fig. 1 9, page 2)
•
Crimping tool (fig. 1 10, page 2)
•
Insulating tape (fig. 1 11, page 2)
•
•
Cable bushing sleeves, if necessary
To fasten the cables you may require additional cable binders.
7.2 Mounting and connecting the camera
Proceed as shown (fig. a, page 7 to fig. f, page 10).
A
NOTICE! Risk of damage!
Ensure that there is sufficient space on the other side for the drill head to come out
I
NOTE
To minimise corrosion in the plug, apply a small amount of grease – such as pin grease
– inside the plug.
Aligning the camera
➤ Use the monitor image to align the camera (fig. g, page 11).
➤ Use the monitor image to check the function of the camera.
EN
Mounting the camera
17