ESAB PEG1 Bedienungsanleitung Seite 11

3. Choice of motors
Check that regulator cards D and E for the wire feed motor and travel motor
respectively are configured for the correct motor, as shown in the table and dia-
gram on page 9.
Regulator card order no. 341 859--880 , --884, --886.
Cable x to pin 1 for A6 VEC 8000 r/min, 4000 r/min.
S
Cable x to pin 1 for Parvalux travel motor (MKR column and boom).
S
Cable x to pin 2 for A6 VEC 2000 r/min.
S
Cable x to pin 2 for A6 Mastertrac for travel.
S
Cable x to pin 3 for A6 VEC 1000 r/min.
S
Cable x to pin 4 for A2 Elektrolux for wire feed (sub--arc welding)
S
Cable x to pin 4 for A6 VEC, 4,000 r.p.m. for travel motion.
S
Cable x to pin 5 for A2 Elektrolux for travel.
S
Cable x to pin 5 for Dunker motor for Multitrac.
S
Cable x to pin 1 for A2 Elektrolux for wire feed (MIG/MAG welding)
S
Cable B to pin 7 for A6 VEC 4000, 2000, 1000 r/min for wire feed.
S
Cable B to pin 7 for Parvalux travel motor (MKR column and boom).
S
Cable B to pin 8 for all A2 motors.
S
Cable B to pin 8 for Dunker motor for Multitrac.
S
Cable B to pin 8 for A6 VEC for travel.
S
Cable B to pin 8 for Mastertrac for travel.
S
Cable B to pin 8 for A6 VEC 8000 r/min for wire feed.
S
Cable B to pin 8 for A6 VBE (DK) for travel.
S
Cable B to pin 8 for spare.
S
Refer also to the table for connection instructions on page 17.
Note: Figures given, e.g: A6 VEC 8000 r/min refer to the actual speed at 42 V
(not rotor version).
dga7i1ea
- - 9 - -
INSTALLATION
aga7d001