Fixing The Kitchen Radio Beneath A Wall Cabinet; Setting Up The Kitchen Radio - Silvercrest KH 2396 Bedienungsanleitung

Fixing the kitchen radio beneath a wall cabinet

Caution:
The following described procedures must only be car-
ried out by persons with corresponding experience
since if they are carried out incorrectly it can lead to
device damage and/or cupboard surface damage.
With the supplied mounting plate q you can fix the kitchen
radio below, for example, a kitchen wall cabinet:
1. Determine a suitable location for the kitchen radio.
2. Press the two retaining levers on the back of the appliance
down. Push the mounting plate q back and remove it.
3. Place the mounting plate q against the installation loca-
tion. Allow 4,5 cm space to the front edges.
This way the kitchen radio will later fit flush.
4. Mark the four points for the drillholes with a pencil.
5. Using a spike, make a small depression at the marking
points. Firmly secure the mounting plate q with the sup-
plied screws.
6. Hold the kitchen radio slanted, with the two recesses
in the retaining lugs on the mounting plate q. Press the
kitchen radio upwards until it noticeably engages.
Disassembly
• To disassemble the kitchen radio, press the two retaining
levers at the rear of the appliance downwards. Then pull
the radio out to the front and remove it.
• Unscrew the screws and remove the assembly plate

Setting up the kitchen radio

Do not set the kitchen radio up without the mounting plate q.
Otherwise the speakers are covered and the sound is scarcely
audible.
To fit the kitchen radio with the supplied mounting plate q:
1. Simultaneously press the two retaining levers on the back
of the appliance down. Push the mounting plate q back
and remove it.
2. Push the two retainer lugs on the mounting plate q into
the recesses on the lower rear side of the kitchen radio.
3. Firmly press the front part of the mounting plate q down
until you hear it engage. You can now set up the radio.
- 55 -
q.