Chamfering Edges; Using The Rip Fence; Using The Fold Depth Stop; Removing/Replacing The Planing Blade - Parkside PEH 30 C3 Gebrauchsanweisung, Originalbetriebsanleitung

♦ Push forward slowly and do not exert excessive
pressure on the plane sole
reduces the surface finish and can lead to a jam
in the chip ejector.

Chamfering edges

The V grooves in the front plane sole
easy chamfering of workpiece edges.
♦ Use the V groove that corresponds to the chamfer
width required.
♦ Place the planer with the V groove
workpiece edge and guide it forwards.

Using the rip fence

♦ To fit the rip fence, guide the connecting screw
through the connecting piece
8b
fence .
♦ Place the washer
8c
.
8b
♦ Screw the lock nut
screw .
8b
♦ Fit the rip fence
fastening screw .
♦ Undo the lock nut
♦ Retighten the lock nut
♦ Ensure that the plane is applied with lateral
pressure.

Using the fold depth stop

♦ Fit the fold depth stop
using the fastening screw
♦ Set the desired fold depth using the fold depth
stop .
♦ Repeat the planing process several times until
the required fold depth is achieved.
PEH 30 C3
. Excessive speed
allow
onto the
and the rip
8a
on the connecting screw
onto the connecting
onto the appliance using the
and set the desired width.
.
onto the appliance
.
Removing/replacing the planing
blade (see figs. C - E)
WARNING! RISK OF INJURY
► Always remove the plug from the power
socket before working on the appliance.
CAUTION!
There is a risk of injury due to the cutting edges
of the planing blade
Never touch the planing blade
edges.
The planing blade has two cutting edges and
can be turned.
♦ Replace the planing blade
edges are blunt.
♦ Do not try to sharpen the planing blade
Turn the planing blade
WARNING! RISK OF INJURY
► Wear suitable protective gloves when changing
the planing blades.
NOTE
► Do not undo the two hex socket screws.
These are used for adjusting the height of the
cutter block. No adjustment is required if you
use the planing blades sold by the manufac-
turer. Use only the planing knives supplied by
the manufacturer.
► When changing the blade, always replace
both blades to prevent an imbalance.
► Unscrew only one blade to start with. This will
allow you to use the factory-mounted second
blade for reference when reassembling later.
♦ Use the supplied open-ended spanner
undo the 3 fastening screws
that the planing blade
(see fig. C).
♦ Push the movable cutter block guard
slot in the housing.
♦ Push the planing blade
clamping element
!
on its cutting
when both cutting
.
or replace it
to
a little way so
can be moved
into the
sideways out of the
(see fig. D)
GB │ MT │
43 ■