Original Accessories/Auxiliary Equipment; Operation; Switching On And Off; Setting The Cut Depth - Parkside PEH 30 C3 Gebrauchsanweisung, Originalbetriebsanleitung

Original accessories/auxiliary
equipment
■
Use only the auxiliary equipment and acces-
sories specified in the operating instructions.
Using parts or accessories other than those
recommended in the operating instructions can
lead to a risk of injury.

Operation

Switching on and off
Switching on:
♦ First, press the safety lock-out
♦ Then press and hold the ON/OFF switch
Switching off:
♦ Release the ON/OFF switch
NOTE
► For safety reasons, the ON/OFF switch
cannot be locked.

Setting the cut depth

Use the dial to set the cutting depth in stages
(level 1–3) according to the cut depth scale
Dust/chip extraction (see fig. A)
WARNING!
Always wear a dust mask!
WARNING! RISK OF INJURY
► Always remove the plug from the power
socket before working on the appliance.
Adjustable chip ejector (left/right):
♦ Unlock the chip ejector
the opposite direction to the arrow (from the
"LOCK" position).
♦ Pull the chip ejector
│ GB │ MT
■ 42
.
.
.
.
by turning it in
out of the appliance.
♦ The chip ejector
plane on the left or the right.
♦ Push the chip ejector
♦ Lock the chip ejector
position "LOCK".
External extraction:
When using dust extraction systems, e.g. a work-
shop extractor, it may be necessary to use the
adapter for external extraction
cleaner must be suitable for the material being
processed.
Connecting:
♦ Push the adapter for external extraction
firmly into the chip ejector
♦ Push the hose of a suitable dust extraction ap-
pliance (e.g. a workshop vacuum cleaner) onto
the chip ejector
extraction , if required).
Removal:
♦ Pull the hose of the vacuum cleaner off the chip
ejector or the adapter.
♦ Pull the adapter for external extraction
Parking shoe (see fig. B)
The parking shoe allows you to put down the
appliance without risking damage to the work-
piece. While working, the parking shoe
flipped up and rear part of the plane sole
exposed.

Planing

CAUTION! RISK OF KICKBACK!
Always switch the appliance on before applying
it to the workpiece.
♦ Set desired cut depth.
♦ Switch the appliance on.
♦ Place the appliance with the front part of the
plane sole on the workpiece.
♦ Move the appliance with straight, even motions
over the workpiece.
can be attached to the
into the appliance.
by turning it to the
. The vacuum
.
(or the adapter for external
is
PEH 30 C3
off.
is