Step 3: Programming The Motion Detector - Abus FUBW50120 Installations- Und Bedienungsanleitung

Installation
Thanks to an internal tamper contact, it is not possible to tamper with the housing or
for it to be ripped from a wall.
Note
A moulded part in the recess of the back plate serves as an anti-removal wall contact.
This moulded part is mounted to the wall with screws.
If this is not done, tamper detection for the wall is deactivated.

Step 3: Programming the motion detector

• Insert the AA batteries provided, ensuring the polarity is correct.
• Remove the insulation sheet after the batteries have been inserted.
• Set the receiver component to programming mode. Follow the instructions provided in your
receiver instructions.
Wireless option
• Trigger the tamper contact of the motion detector to send a tamper message to the receiver
component.
IR option
Note:
The detector's IR programming mode only lasts for a short time after the batteries have been
inserted.
See Chapter "Operation of the LEDs"
• The IR programming is active if the red LED flashes 4 times.
• Hold the LED of the motion detector close to the IR receiver of the wireless extension (RFX)
so that the detector can send an IR message to receiver component.
• Ensure that the motion detector has been recognised by your receiver component.
52 | E N