Restore Factory Settings - HomeMatic IP HmIP-WTH-B Zusatz Zur Montage- Und Bedienungsanleitung

10

Restore factory settings

The factory settings of the device can be restored.
If you do this, you will lose all your settings.
To restore the factory settings of the device, proceed as
follows:
Once mounted, the electronic unit (A) can easily
•
be pulled out of the mounting plate. Take hold of
the sides of the electronic unit and pull it from the
mounting plate.
• Remove a battery.
• Insert the battery ensuring that the polarity is
correct and press and hold down the system
button (C) for 4 s at the same time, until the LED
will quickly start flashing orange (see figure 15).
• Release the system button (see figure 16).
Press and hold down the system button (C) again
•
for 4 seconds, until the LED lights up green (see
figure 17).
• Release the system button to finish the procedure.
The device will perform a restart.
Restore factory settings
75