NOTE
►
Press the
alarm time for a few seconds in the display
►
In the event of a power failure, any programmed alarm times will be deac-
tivated and not reactivated when the power comes back if no batteries are
inserted in the battery compartment
Interrupt alarm (SNOOZE function)
♦
You can interrupt the alarm for 9 minutes by using the SNOOZE function. To
do this, press the SNOOZE | SLEEP button
If the SNOOZE function is active, either
the display
Switching off the alarm
♦
While the alarm is sounding, press either the
| AMS button
the alarm for 24 hours.
NOTE
►
If the alarm is not manually deactivated, the device will switch off the alarm
automatically after 1 hour.
Switching the alarm off completely
Requirement: The device is in clock/standby mode.
♦
To switch off Alarm 1 or Alarm 2 completely, press the
z
or the
hours flash in the display
♦
Press the
type
♦
Turn the −TIMER+ dial
♦
Press the
setting.
Switching the radio mode on/off
NOTE
►
The technical features of this device enable an adjustable reception capa-
bility that exceeds the permitted FM frequency range of 87.5–108 MHz.
In some countries, different national regulations may apply to the assigned
radio frequency ranges. Please note that information received outside of the
assigned radio frequency ranges may not be exploited, passed on to third
parties or otherwise misused.
♦
Briefly press the −VOLUME+ |
SKR 800 C3
| MEM button
z
4
depending on the alarm type which has been set.
e
or the −VOLUME+ |
| AMS button
e
4
.
| MEM button
z
or
or
or
8
to the right to set the alarm type to
| MEM button
z
| AMS button
or the
4
.
d
.
t
as soon as the alarm sounds.
or
or
| MEM button
/FUNC. dial
for about 2 seconds until the alarm time
| AMS button
or the
4
flash in the display
| AMS button
or the
1
/FUNC.dial
to switch the device on.
e
to show the
or
flashes in
z
or the
1
to switch off
| MEM button
e
until the alarm
.
(Off).
e
to save the
GB │ MT
│
93
■