IKEA HYGIENISK Handbuch Seite 13

ENGLISH
• Activation or deactivation of the
AutoOpen.
As the appliance stores the saved
settings, there is no need to configure it
before every cycle.
How to set the programme selection mode
The appliance is in programme selection
mode when the display shows the
programme number P4.
After activation, the appliance is in
programme selection mode by default. If
not, set the programme selection mode the
following way:
Press and hold RESET until the appliance is
in programme selection mode.
How to enter user mode
Make sure the appliance is in programme
selection mode.
Water hardness
German degrees
(°dH)
47 - 50
43 - 46
37 - 42
29 - 36
23 - 28
19 - 22
15 - 18
11 - 14
4 - 10
<4
1) Factory setting.
2) Do not use salt at this level.
French degrees
(°fH)
84 - 90
76 - 83
65 - 75
51 - 64
40 - 50
33 - 39
26 - 32
19 - 25
7 - 18
<7
To enter the user mode, press and hold
simultaneously
indicators
flash and the display is blank.
The water softener
The water softener removes minerals from
the water supply, which would have a
negative effect on the washing results and
on the appliance.
The higher the content of these minerals, the
harder your water is. Water hardness is
measured in equivalent scales.
The water softener should be adjusted
according to the hardness of the water in
your area. Your local water authority can
advise you on the hardness of the water in
your area. It is important to set the right
level of the water softener to assure good
washing results.
mmol/l Clarke de-
grees
8.4 - 9.0 58 - 63
7.6 - 8.3 53 - 57
6.5 - 7.5 46 - 52
5.1 - 6.4 36 - 45
4.0 - 5.0 28 - 35
3.3 - 3.9 23 - 27
2.6 - 3.2 18 - 22
1.9 - 2.5 13 - 17
0.7 - 1.8 5 - 12
<0.7
and
, , ,
Water softener level
5
< 5
1
13
until the
, and
10
9
8
7
6
1)
4
3
2
2)