Set Temperature - mundoclima MUPIR-H9 Installations- Und Benutzerhandbuch

6.3.2

Set Temperature

When heat pump is on, short-press or into water temperature setting
surface, symbol displays normally, Setting area's temperature value twinkles, press
or to select value, press to confirm and exit current setting. No any
set up after 30 seconds, the controller will save the last setting and go back to original
surface.
6.3.3 Parameters query and Parameters configuration functions
When unit is running or standby, press Mode button for 3 to 5 seconds, the unit will be in
query or configuration status. At this time, the percent section of output rate icon will flash
with PQ letter. Press Up or Down button, and the displayed letter will in turns as following
figure:
Notes:
PQ: Parameter Query interface;
PS: Parameter Setting interface; (Only available for factory)
HF: History Fault interface;
DS: Debug Status interface. (Only available for factory)
After select one interface from above 4 interfaces, press Mode button to confirm and enter
the selected interface.
48