Niko 10-362 Produktinformation Seite 56

10-362
Basic (only with code lock module)
Extended (code lock module)
7. CONFIGURATION
• The display module can only be configured using the Niko Configuration SW.
• Configuration using the keys or the service unit 10-870 is not possible.
• The end user, for example the building manager, can also use the Niko Configuration SW to update the name list.
• All configuration data and the resident database are stored on a permanently installed EEPROM.
• The data will also be copied to the EEPROM after each configuration. If necessary this memory can be deleted, without interrupting the functionality.
7.1. Factory settings
The device is equipped with an EEPROM, in which the following default settings are saved:
Mode backlight
Start screen
Database
a)
Temperature sensor
Temperature unit
AD2 mode display
10-850 direct dialling
Activate preselection with first letters
a) Temperature sensor: A single flush-mounting temperature sensor can be used.
7.1.1. Preset times
Time-out for backlight in automatic mode
Error detection "key is locked" (key pressed for longer than 25 s)
7.2. Configuration options
Function
Draw up resident list (allocation of the 1
Set ExtU address
Activate temperature display
Display temperature in °F (Fahrenheit)
Activate AD2 mode b)
56
st nd
and 2 internal unit by name and number)
Image 8: Standby Basic
Image 9: Standby Extended
a)
automatic mode
Logo Niko
no datasets
deactivated
°C (Celsius)
activated
deactivated
deactivated
30 sec.
25 sec.
Niko Configuration SW
x
x
x
x
x
EN