Installing The Dust Extraction System; Operation; Residual Current Circuit Breaker; Switching On And Off - Parkside PDFS 1300 A1 Originalbetriebsanleitung

Installing the dust extraction system

On delivery, the connection point of the adapter
for dust extraction is closed off. To install the
dust extractor, proceed as follows:
♦ Remove the screws
remove the protective cover
♦ Using the screws
for dust extraction
♦ Connect an approved dust and chip extraction
device.

Operation

WARNING!
► Prevent dripping water from dripping along
the power cord into the power outlet or plug.
To do this, form a loop from the mains cable
underneath the mains socket. This prevents
any dripping water from getting into the
mains socket.

Residual current circuit breaker

WARNING!
► Check the correct function of the residual
current circuit breaker before each use
♦ Connect the residual current circuit breaker
to the power grid.
♦ Press the reset button
is red.
♦ Press the Test button
black. This shows that the test was successful.
If the indicator continues to indicate red, the
residual current circuit breaker
and must be repaired by qualified personnel!
WARNING!
► Do not operate a appliance with faulty circuit
breakers!
♦ After a successful test, press the reset button
again to switch the appliance back on.
│ GB │ MT
■ 58
from the housing and
.
provided, fasten the adapter
onto the dust outlet
until the indicator
until the indicator
is defective
Switching on and off
WARNING!
► To avoid the risk of electric shock, make sure
that no water gets into the appliance. Do not
touch the power plug with wet hands.
CAUTION!
.
► Wait until the appliance has reached the
maximum speed and use a low feed rate to
achieve clean cuts.
Switching on:
♦ Press the ON/OFF switch
Switching off:
♦ Release the ON/OFF switch

Setting the cutting angle

You can change the cutting angle using the cutting
angle scale
■ Undo the wing screw of the cutting angle pre-
selector
angle scale

Setting the cutting depth

!
NOTE
► We recommend that the cutting depth should
be approx. 3 mm greater than the material
thickness. This ensures that you achieve a
clean cut.
is
► To determine the correct setting, you can
place the machine on the edge of the
material to be machined so that the cutting
disc can swing freely downwards when
the locking screw
cutting disc
beyond the material thickness, tighten the
locking screw
► Use a similar procedure if you want to mill
a groove.
► We recommend testing the setting on a sample
piece of material.
♦ Undo the locking screw
cutting depth and tighten the locking screw
again.
.
.
.
. Set the desired angle on the cutting
and retighten the wing screw
is loosened. Once the
protrudes approx. 3 mm
.
. Set the desired
PDFS 1300 A1
.