CAME V6000 Installationsanleitung Seite 37

Movement control and obstacle detection
When OPENING:the door stops. To
resume movement, either press a button
or use the transmitter.
When CLOSING: inverts the
direction of travel until opening is
complete.
After three consecutive inversions,
the door stays open and excludes
the automatic closing: to close,
either use the transmitter or button.
Power supply
The operator is supplied with an electrical cable (L = 1.2 m) with an already connected Shuko plug.
Command and control devices
Stop button (NC contact). Enables the door to stop and excludes the automatic closing. To resume movement
either press the control button or any other control device.
Safety devices
TX
RX
OPEN-STOP-CLOSE-STOP
function from control device (NO
contact).
If a device is connected, remove the bridge
If a device is connected, remove the bridge