Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
d) Volume measurements
• Press the
functions menu.
• Press the + (9) or - button (12) to select the volume
measurement mode ( ) and confirm your selection with
the MEAS button (4).
• Measure the three orthogonal side lengths of the volume
(length [1], width [2] and height [3]) by aligning the
measuring device appropriately. Refer to the measuring
sequence and the device orientation indicated by the
digits in the diagram above.
• The measured values will appear individually on the
display with the measurement number (A). The device
automatically multiplies the measured values and displays
the volume.
e) Indirect measurements
The Pythagorean theorem (a
to indirectly determine the height of an object.
Make sure that the starting point for each
measurement is exactly the same position.
Height measurement with two reference points
A reference end point must be at right angles to the vertical
line (line 2), e.g. when you are at the foot of a building. Line 2
must be measured on the point that is horizontally opposite.
• Press the
functions menu.
button (3) to access the measurement
button (3) to access the measurement
+b
=c
) can be used
2
2
2
61
Werbung
Kapitel
Inhaltsverzeichnis
